• CMahaff@lemmy.world
    link
    fedilink
    English
    arrow-up
    30
    ·
    1 year ago

    I saw this complaint in another post online (paraphrased):

    The screen and use of a Pi seem at odds with each other. The screen is ultra-low power, but there are of course huge drawbacks for usability. Meanwhile the CPU is very powerful, but chews through, comparatively, a lot of power quickly.

    They argued that it would be better to either pair the Pi with a better screen for a more powerful/usable handheld, or go all in on longevity and use some kind of low-power chip to pair with the screen for a terminal that could last for days.

    … I’ve got to say, it’s a fair point. A low power hand-held that could run Linux and run for days would be pretty cool, even if it was underpowered compared to a Pi. No idea what you could use for such a thing though.

    • OppositeOfOxymoron@infosec.pub
      link
      fedilink
      English
      arrow-up
      6
      ·
      1 year ago

      Total newb question – don’t these CPUs support multiple clock speeds? You could set it high on install in preparation for compiling a bunch of software, then once you’re done, knock it down to 50% or less of the maximum to add longevity?

      • CMahaff@lemmy.world
        link
        fedilink
        English
        arrow-up
        7
        ·
        1 year ago

        Not an expert myself, but I think chips that truly sip power not only have a much lower floor but take even more aggressive actions to reduce power when idle.

        Certainly with the right software tuning you could aggressively throttle the CPU to save power - I’m just not sure how much power it would actually save.

        I did find this really good article on reducing the Raspberry Pi Zero 2W power consumption: https://www.cnx-software.com/2021/12/09/raspberry-pi-zero-2-w-power-consumption/

    • meyotch@slrpnk.net
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      I’m toying with the idea of pairing this through the gpio pins on the pi to an A9G 4G/GPS module and a battery. With voice, text, data and location, you could do anything. Bulky as heck by the time you encase it but it could be cool.

  • nutsack@lemmy.world
    link
    fedilink
    English
    arrow-up
    11
    arrow-down
    1
    ·
    edit-2
    1 year ago

    I don’t need a fucking playground Steven I’m not a little kid and you’re not my dad stop coming to my house

    • directive0@lemmy.world
      link
      fedilink
      English
      arrow-up
      8
      ·
      1 year ago

      Adafruit was rolling through runs of ~70 per day for a while. First come first served. Dunno if they still are. I’d suggest setting up a stock alert with them.

      I snagged one for my Beepy. They were so strict about scalpers they made me set up 2fa so they could verify my account.

    • Billygoat@catata.fish
      link
      fedilink
      English
      arrow-up
      5
      ·
      1 year ago

      That’s what I was thinking. I don’t think I’ve seen them available in the last 3 months.

    • fuckwit_mcbumcrumble@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      If you’re near a microcenter they usually keep them hidden and you have to ask for them. But even when they’re hidden they sell out the day the shipment gets there.

      Online will probably be a shit show forever thanks to scalpers.

    • thann@lemmy.world
      link
      fedilink
      English
      arrow-up
      11
      ·
      1 year ago

      Incidentally, you’ll want to avoid draining the Beepy’s battery too deeply if you can help it — according to the schematics (and confirmed on my actual hardware) SQFMI have used a 10K resistor on the “programming” pin of the TP4054 charging IC. That sets the chip’s charge rate to a measly 100 mA, which means a full recharge of the battery would take somewhere in the neighborhood of 20 hours. It’s hard to believe this was intentional, and may be addressed on a later hardware revision.

      Yeah, this is a really cool idea, but they need to flush it out a little more. analogue audio and faster charging would make it a lot more appealing

        • thanevim@kbin.social
          link
          fedilink
          arrow-up
          3
          ·
          1 year ago

          Has me wondering if ever we’ll reach a state where we just have battery packs like backpacks that we just wear as a daily habit, like putting a shirt on. It’ll charge up overnight, then go in a sleeve that’s machine washable (otherwise ew), and have a half dozen or so PD USB-C ports that we just tap into for phones, smart watches, laptops, etc

          • _haha_oh_wow_@sh.itjust.works
            link
            fedilink
            English
            arrow-up
            3
            ·
            1 year ago

            People definitely care battery chargers around and I’ve seen some that are integrated into backpacks already so it’s kind of already started. I heard the chargeable backpacks are kinda meh though and you’re pretty much better off just sticking some batteries in your pack.

      • havokdj@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        20 hours

        What the fuck. Yes it is a cool product, THAT however needs to be fixed before they launch this thing. 20 hours? Imagine trying to implement this for some kind of project and having to wait basically a whole goddamn day for it to charge lmao

    • fuckwit_mcbumcrumble@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      In order to keep costs down the Pi is based on some pretty ancient hardware. DDR2 uses so much power no matter what, it’s not like modern stuff that uses nothing idle.