I’d have to check my iptables syntax again but I’m not sure you want the FORWARD between the networks unless C has a manual route to get traffic for the 192.168.15.0/24 network back via B. You just want to NAT A behind B’s IP on 192.168.38.0/24. I think the forwards are sending the traffic without doing NAT on A.

Phillips SonicCare for 20+ years. I think it’s helped me a lure with my dental care. Various models as the batteries wear out. The latest has Bluetooth that I never use but that doesn’t affect the cleaning part.

The phone or browser may be using DNS over HTTP (aka DoH), check if you can disable it for the wifi network. You may have to disable it on the phone or browser to get your desired behaviour - look up directions for your browser.

If it’s logs, there’s a package called log2ram - it’s designed for small form factor systems to reduce writes to SD cards but does apply anywhere you want to log but not hit disk immediately. It syncs logs to disk on a regular basis so you don’t lose much if the system crashes.

From a Linux command line it would be the command called arp, you need to add a static arp entry. I don’t know how that works on sense, but on Linux it would be something like arp -s IP MAC

Maybe there’s a module in opnsense to help. The way I’ve done this before is using a machine connected to the same network at my target to wake up by logging into that machine and issuing the wake command.

WoL packets are usually sent to the ip broadcast address for the network as they’re not ip based. I don’t know if this would ever work well across networks. Can you do send the wol packet from the opnsense router instead? Does it work then?

If you’re sending it to the IP of the server, it likely works soon after your turn the machine off because the ARP entry hasn’t timed out yet, but once it times out it won’t work anymore. The router doesn’t know how to get to the machine. You may be able to add a static arp mapping to get it to work long term.

All that yes. The Wooting One (original that uses IR light) let you use buttons to simulate controller axes, change how hard you need to press to activate, and add second functions to keys. It was an interesting idea but I found the gaming part the original keyboard to be only usable in a limited set of games as it’s not as sensitive as a controller stick, and as a keyboard it wasn’t great either. Hopefully V1 problems, I know they had through another version of the IR keyboard, and then came out with the Hall effect keyboard. I like the idea but never could get used to it, and when the spacebar was loose I retired it after fixing it.

Yes, the packet passes through routers at each stage and they direct the packet to the ‘closest’ path based on its destination, until the final router has the destination on its network. This can happen a few times (for something in your ISP network), or 10-30+ times for something further away.

I’m not sure how consistent it is but the static binaries I have for btrfs-progs are about 2x larger than their dynamic counterparts. If you statically compile it only the functions actually used are included in the binary, so it really depends on how much of the library is used.

In general, if you haven’t taken steps to expose your service to the Internet, it’s not accessible over or to the internet. Your router that connects you to the Internet should have a firewall that blocks all inbound, unsolicited requests, and you also need to do something explicit with most self hosted service to expose them, they will not announce themselves to the world.

In addition if you’re using an ipv4 network address that’s likely a private address (like 10.x.y.z, 172.x.y.z, or 192.168.x.y), which also isn’t accessible outside of your network.